Skip to content
Pump Calculators

Pump Calculators

Free Pump Calculators & Sizing Tools

Calculate pump head, horsepower, efficiency, operating cost and other pump-system requirements with practical calculators built for professionals and everyday users.

Total Dynamic Head Calculator

Basic inputs

Discharge elevation minus source liquid-surface elevation. Negative if the discharge is below the source.

ft

Pressure needed at the discharge. Blank counts as 0.

psi
gpm

Straight runs only; 0 means no pipe friction.

ft

Actual inside diameter, not nominal size.

in

Automatic pipe friction also needs the pipe's absolute roughness — enter it under Advanced options (0 for a smooth pipe). No value is assumed.

Result

— ft

Fill in the inputs, then press Calculate.

Calculation results are estimates based on the inputs and assumptions shown. Verify equipment selection against current manufacturer data and applicable requirements. Do not rely solely on this calculator for safety-critical design decisions. See Disclaimer

How total dynamic head is calculated, with a worked example →

Head & Pressure

Total Dynamic Head Calculator

Combine elevation, required pressure and system losses into the head your pump must produce.

Well Pump Size Calculator

Estimate the GPM and total dynamic head a residential well pump must deliver.

Friction Loss Calculator

Calculate straight-pipe friction loss for water in feet of head and psi.

Pool Pump Size Calculator

Find the GPM and total dynamic head a pool pump must deliver from pool volume and turnover time.

Pressure to Head Calculator

Convert pressure readings into feet of head for your fluid.

Coming soon

Power & Energy

Pump Horsepower Calculator

Estimate hydraulic and shaft power from flow, head and efficiency.

Pump Efficiency Calculator

Compare hydraulic output to power input.

Coming soon

Pump Operating Cost Calculator

Estimate the electricity cost of running a pump.

Coming soon

Pump Performance

Pump Affinity Laws Calculator

Predict how flow, head and power change with speed or impeller diameter.

Coming soon

How pump sizing generally works

Horsepower alone does not determine which pump to buy. A pump is selected for an operating point — a flow at a head — and then checked against the real system.

  1. 01

    Determine required flow

    Determine how much fluid the system needs to move.

  2. 02

    Calculate total dynamic head

    Account for elevation, required pressure and system losses.

  3. 03

    Determine required pump power

    Estimate hydraulic and shaft power requirements.

  4. 04

    Check the pump curve

    Verify that the actual pump can deliver the required flow at the calculated head.

  5. 05

    Verify the system

    Confirm efficiency, suction conditions, NPSH and application-specific requirements where appropriate.